diff --git a/documents/README/YamBMS_functions.md b/documents/README/YamBMS_functions.md index 96a6ad6..a7e1fe8 100644 --- a/documents/README/YamBMS_functions.md +++ b/documents/README/YamBMS_functions.md @@ -101,8 +101,8 @@ You can compare `Auto CVL` to cruise control in a car. ## Auto CCL & DCL > [!IMPORTANT] -> The `Auto CCL` function uses the `OVPR` value of your BMS which must be higher than `cell_bulk_voltage` to work properly. `e.g. for LFP` : CVL=3.45V / OVPR=3.55V / OVP=3.65V. -> The `Auto DCL` function uses the `UVPR` value of your BMS. `e.g. for LFP` : UVPR=3.00V +> The `Auto CCL` function uses the `OVP` value of your BMS. +> The `Auto DCL` function uses the `UVP` value of your BMS. Regarding the new `Auto Charge/Discharge Current Limit`, this features has been introduced to hopefully prevent `OVP` and `UVP` alarms. @@ -111,7 +111,7 @@ This should prevent the runner cell from exceeding the max voltage cutoff, but d You can compare `Auto CCL` to a max speed limiter in a car. -`Auto DCL` works the same way when a cell approaching `UVPR`. +`Auto DCL` works the same way when a cell approaching `UVP + 0.02`. Current control should work with any inverter that uses `CAN` control. @@ -123,7 +123,7 @@ These 4 sensors allow you to see what is being requested of your inverter. In the example below, we are in the `Float` phase at a voltage of `53.6V` and an `Inverter Offset V.` of `0.1V`. The `Requested Charge Voltage` is therefore `53.7V`. -The `Requested Discharge Voltage` is the `UVPR` value of your BMS multiplied by the number of cells, in this example (3V * 16). +The `Requested Discharge Voltage` is the `UVP + 0.02` value of your BMS multiplied by the number of cells, in this example (3V * 16). The `Requested Charge/Discharge Current` is the `OCP` value of your BMS multiplied by the `Max current` percentage, in this example (150A * 80%).