Files
esphome-yambms/documents/README/Supported_devices_Build_your_own_PCB.md
T
2024-12-23 22:42:35 +01:00

2.1 KiB

YamBMS - ESP32 or ESP32-S3

Badge License: GPLv3 Badge Version GitHub stars GitHub forks GitHub watchers

Important

BMS monitoring with UART or RS485 is recommended.

Number of BMS supported

  • 2x BMS with Bluetooth (BLE stack consumes significant amount of RAM on device and can cause crash and reboot)
  • 3x JK-B BMS with UART/RS485
  • several JK-PB BMS with RS485 (already tested with 7 BMS)

Note: these are theoretical limits, not all combinations have been tested.

UART/IO Expander

It would be possible to add one or more WK2168 4x UART expander to increase the number of BMS monitored with UART.

Build your own PCB

Caution

The GND of the JK-B GPS port is directly connected with the B- of your battery. Even if your BMS is in protection or stopped you can measure the full voltage between this GND and B+. This therefore presents a risk of bypass of the BMS P- and can be dangerous if the GND of your ESP32 is connected to the GND of your inverter or a measurement shunt for example. I therefore strongly advise you to achieve galvanic isolation between your ESP32 and the UART-TTL of the JK-B GPS port.

This is an example of an ESP32 DevKit V1 30 pin board powered by the JK-B BMS. This example uses an RS485 board for the multi-node solution which is not mandatory.

Image

Image