2.1 KiB
YamBMS - ESP32 or ESP32-S3
Important
BMS monitoring with
UARTorRS485is recommended.
Number of BMS supported
- 2x BMS with
Bluetooth(BLE stack consumes significant amount of RAM on device and can cause crash and reboot) - 3x
JK-BBMS withUART/RS485 - several
JK-PBBMS withRS485(already tested with 7 BMS)
Note: these are theoretical limits, not all combinations have been tested.
UART/IO Expander
It would be possible to add one or more WK2168 4x UART expander to increase the number of BMS monitored with UART.
Build your own PCB
Caution
The
GNDof theJK-B GPS portis directly connected with theB-of your battery. Even if your BMS is in protection or stopped you can measure thefull voltagebetween thisGNDandB+. This therefore presents a risk ofbypassof the BMSP-and can be dangerous if the GND of your ESP32 is connected to the GND of your inverter or a measurement shunt for example. I therefore strongly advise you to achieve galvanic isolation between your ESP32 and theUART-TTLof theJK-B GPS port.
This is an example of an ESP32 DevKit V1 30 pin board powered by the JK-B BMS. This example uses an RS485 board for the multi-node solution which is not mandatory.

