* Update unit_of_measurement from mV to V and apply scaling filter for voltage readings
* Change readings to use multiply instead of filters for scaling
* Changed number components to use lambda functions for value conversion
* Enhance online status binary sensor to validate BMS communication based on total voltage reading
* Update version numbers and update dates in YAML configuration files
* Update BMS min/max temperature filters to filter out noise
* Add filters for Basen temperature sensors
- Basen temperature sensors only have full integer resolution. Add additional filters to reduce noise.
* Update filter for min/max temperature
- Change filters for min/max temperature to reduce noise introduced by changes in the lowest bit (0.1°C). Otherwise this noise will be forwarded by auto temp based current to the requrested charge/discharge current and therefore to the inverter.
* CCL, DCL and Auto Temp Current Control
* Added following:
- Update temperature based current derating, now uses calibrate_linear
- Revised CCL and DCL to correctly apply derating when multiple functions are enabled
- Added diagnostic sensor showing derating reason
* Changed referenced sensor for Auto DCP temperature derating
* Updated Auto Temp logic
* Add documentation, rename package
* Rebase was a mess, so re-adding based on the dev branch.
* updates for the 1.6.0 release / dev branch to compile.
* Update external component source version
* Updated the external component source version from main to v1.0.0.
* Update external component source version to v1.0.0
* Add an example for EG4.
Because of temperature based current limitation, the requested charge/discharge current could be non-integer values. For the used high-power applications, sub 1A precision is not required and may add noise.
* Adding FLIP_C3 board
The FLIP_C3 is a simple ESP32-C3 board that has an integrated power supply that has a 60V input. This board can be connected directly to a 48V battery and then be used with the M5Stack Isolated RS485 Unit (U094) to get a RS485 connection back to the master unit. I successfully used 4 of these units to communicate with the JK-BMS B-Series BMS's. The FLIP_C3 has an onboard 5V regulator that can power the RS485 module, 2 UART exposed on connectors that can be used for TTL to the BMS and TTL to the RS485 module. In the US it is available on Amazon, product page: https://wiki.vdbx.io/product/flip_c3
* Added missing GPIOs to FLIP_C3 board