2.3 KiB
YamBMS - ESP32 or ESP32-S3
Important
BMS monitoring with
UARTorRS485is recommended.
BMS Support Capacity
Based on hardware limitations and testing, this board supports:
| Communication Method | Maximum BMS | Notes |
|---|---|---|
| RS485 | Multiple BMS | Best option for monitoring many BMS units |
| UART | 3× BMS | Must be connected to the GPIOs header |
| Bluetooth (BLE) | 3× BMS (ESP32-S3) | BLE stack consumes significant RAM, may cause crashes/reboots |
Note: These are theoretical limits. Not all combinations have been tested.
UART/IO Expander
It would be possible to add one or more WK2168 4x UART expander to increase the number of UART port.
Build your own PCB
Caution
The
GNDof theJK-B GPS portis directly connected with theB-of your battery. Even if your BMS is in protection or stopped you can measure thefull voltagebetween thisGNDandB+. This therefore presents a risk ofbypassof the BMSP-and can be dangerous if the GND of your ESP32 is connected to the GND of your inverter or a measurement shunt for example. I therefore strongly advise you to achieve galvanic isolation between your ESP32 and theUART-TTLof theJK-B GPS port.
This is an example of an ESP32 DevKit V1 30 pin board powered by the JK-B BMS. This example uses an RS485 board for the multi-node solution which is not mandatory.

