The DevKitC-1 swapped the RGB LED between V1.0 (GPIO 48) and V1.1 (GPIO 38),
and the freed pin is the one PVbrain2 uses for CAN TX. Both pins are therefore
board-revision dependent and cannot stay hardcoded in a single board file.
board_ESP32-S3_DevKitC-1_PVbrain2.yaml becomes the common base :
- tx_pin_4 / rx_pin_4 and the LED strip pin are removed from it
- esp_light now reads ${rgb_led_pin}
- GPLv3 header added, which was missing
Two thin wrappers provide the revision-specific pins and include the base :
- board_ESP32-S3_DevKitC-1_PVbrain2_LED-48.yaml : V1.0, LED 48 / CAN TX 38
- board_ESP32-S3_DevKitC-1_PVbrain2_LED-38.yaml : V1.1, LED 38 / CAN TX 48
YamBMS_LP_PVbrain2.yaml and YamBMS_RP_PVbrain2.yaml include the LED-48 variant,
the LED-38 line being commented right next to it.
Same split applied to the RS485 Pylontech package : the content moves to
yambms_rs485_pylon_core.yaml and yambms_rs485_pylon.yaml keeps only the uart
baud_rate extend, so PVbrain2 — whose board already declares the UART — can
include the core directly.
PCB LED 1 / PCB LED 2 / ESP32 LED are no longer prefixed by ${name}, and the
`name` substitution is added to the PVbrain2 root YAMLs.
- Adjusted light control logic to handle RGB settings and state changes more effectively.
- Introduced a new substitution `board_has_rgb` to indicate RGB functionality availability.
- Removed the deprecated `board_options_rgb_led_status.yaml` file.
- Enhanced CAN bus and RS485 configurations to include LED control based on device status.
- Updated T-Connect and YamBMS behaviour documentation
* CCL, DCL and Auto Temp Current Control
* Added following:
- Update temperature based current derating, now uses calibrate_linear
- Revised CCL and DCL to correctly apply derating when multiple functions are enabled
- Added diagnostic sensor showing derating reason
* Changed referenced sensor for Auto DCP temperature derating
* Updated Auto Temp logic
* Add documentation, rename package
This adds 'yambms_max_inverter_charge_current' and 'yambms_max_inverter_discharge_current' substitutions. They are used to restrict the range of the charge/discharge current for easier control when the battery currents are much higher than the inverter currents.